Now that we’re all set up – time to fire up the client. ![]() Sudo /usr/local/bin/noip2 -C (ONLY required if you want to recreate the file due to entering something wrong) Start the client If you just realised you entered something wrong there, use the following command in Terminal to recreate the config file: This should now be all set and ready to go. I think this is minutes, so I just used 30. It also says something along the lines of “Do you want to complete other actions” – I just typed ‘N’ for ‘no’ and hit enter again. Just enter those and press Enter after each. It will do some ‘stuff’ then ask you for your No-IP account log-in and password. Press enter, let it finish, then enter the following: Time to finish installation and enter your No-IP account details. If this happens, whilst in the ‘noip’ directory enter ls and press enter to check the version number/name.) Install and confirm your No-IP account information (If that doesn’t work, the version number may have changed/updated. We just extracted the file which made a new directory in our ‘noip’ directory. The last step downloaded the No-IP client as an archive file. Let it do its thing until Terminal becomes available again. We will now download the No-IP client into this directory. In the previous step we set ourselves in the noip directory. ![]() Still in Terminal, enter the following to go to the new directory we just created: Step 2: Install and Set Up the No-IP client software Create a ‘noip’ Directoryįirst, let’s create a directory (folder) for the No-IP client software to be installed into.
0 Comments
Leave a Reply. |